Download WinUAE 3.2.2

Version 3.2.2 of WinUAE has been released recently. This Windows port of the UAE Amiga Emulator is able to emulate a Commodore Amiga perfectly. All models, from the very first Amiga 1000 to the Amiga 4000, are supported. However, you should keep in mind that WinUAE comes without kickstart, so to speak the bios/firmware of an Amiga, or other software. More information can be found in the Amiga Emulator FAQ are being found. WinUAE runs on Windows 2000 and above, and the download is less than 6MB in size. Amiga Forever is a possible solution for a kickstart and programs, with prices starting at 10 euros. Since version 3.2.0, the following improvements have been made:

WinUAE 3.2.2

Bug fixed:

• JIT FPU 32-bit and 64-bit compatibility fixes.
• Interlace mode blank screen in some configurations.
• Slirp network mode high CPU usage.
• Some programs that use AGA subpixel scrolling had horizontal jittering.
• Per-monitor high DPI update still caused repeated GUI window closing/opening.
• Game controllers suddenly stopped working. Most likely only happened under Windows 10 and only in some setups.
• MIDI out devices missing (x64 only).
• Serial port transmit buffer was not always flushed.
• 68020+ BFFFO undocumented offset calculation fixed.

Updates:

• AVIOutput in capture before filtering mode: width is now always divisible by 16 pixels and height is always even for best codec compatibility.
• Useless, very basic and invisible touch screen mouse and joystick overlay.
• Load config with joystick that is not connected, fall back to previously loaded (default.uae) setting instead of always falling back to keyboard layout A.
• Out of bounds RTG coordinates are now clipped to valid region instead of rejecting whole operation.
• Keyboard names (if available) are now listed in Input panel device list.
• Built-in HRTmon update v2.36.
• Phoenix Board SCSI emulation.

WinUAE 3.2.1

Bug fixed:

• Loading state file with enabled FPU crashed.
• Custom chipset display was shifted in some rare situations.
• 64-bit version didn’t load DLLs without x64, _64,… extension in name.
• RTG board was not fully disabled if configured RAM config was incompatible.
• 68040+ CPU mode state file save buffer overflow.
• Unaligned supervisor stack was not allowed in 68020+ modes.

Updates:

• Reduce RAM size and try again if Blizzard RAM allocation fails.
• Switch off triple buffering if windowed mode with DWM active.