Download Firmware Nikon WR-1 1.02

Nikon has for its WR-1wireless remote control new firmware released. This remote works in conjunction with Nikon’s SLR cameras with a ten-pin remote terminal or accessory terminal and allows you to control important camera functions remotely. The built-in screen allows you to configure advanced functions, operate the camera menus and change settings. In addition, it can cooperate with various remote controls to control different cameras. The firmware version number is fixed at 1.02 and this version contains the following changes:

Changes from firmware version 1.01 to 1.02

• Added support for the Z 7 and Z 6.

Changes from firmware version 1.00 to 1.01

• ISO sensitivity display is now supported for the D5 and D500. If you are using two WR-1 units, one as a receiver and the other as a transmitter, update both to firmware version 1.01. If you are using the WR-1 with a WR-R10, have a Nikon-authorized service representative update the WR-R10 to firmware version 3.00.
• When used as a transmitter to change ISO sensitivity for a receiving camera, the WR-1 no longer needs to cycle continuously through the available values.

Important: Before performing the update, attach the WR-1 to the camera, slide the Tx/Rx/OFF switch to Rx and wait at least 10 seconds.