Download Firmware Linksys WRT160N 2.0.02 Build 15 / 3.0.02 Build 3

Linksys has for its WRT160Nbroadband router released new firmware. You must pay attention to the hardware revision of the router; Revision 2 can be equipped with firmware 2.0.02 build 15 and revision 3 can be equipped with firmware 3.0.02 build 3. Unfortunately, no new firmware has been released for revision 1 of this broadband router. The list of changes for both releases is as follows:

Version 2.0.02 build 15:

• Fixed issue with downloaded files size reported.
• Fixed improper wide channel when auto channel select.
• Fixed failure to report wireless client statistics.
• Fixed PPPoE disconnect button not sending out termination packet.
• Fixed GUI when entering PIN for Wi-Fi protected setup.
• Fixed GUI with Wi-Fi protected setup with Passphrase being more than 20 characters will cause connection to fail.
• Fixed WPA or WPA2 phasphrase does truncates only allows for 20 characters.
• Fixed DHCP client for router behind router connection.
• Fixed DynDNS having problem with username and password improperly giving error message when Hose name is blank.
• Fixed DynDNS allowing for more character than it is allowed.
• Fixed Save settings button not always sending HTTP GET message.
• Fixed GUI with Factory default screen.
• Fixed conflicting HNAP action by two clients.
• Fixed DynDNS does not send out updates request for IP change.
• Fixed RIP does not reply with the next hop.
• Fixed RIP changes does not go to effect immediately.
• Fixed Domain name not being properly handled.
• Fixed when setting to remote management, it gets redirected to Upgrade screen.
• Fixed acceptance to non-valid wireless settings.
• Fixed NTP with DHCP internet connection.
• Fixed DNS not resolving URL.
• Fixed L2TP internet connection improperly getting new IP address.
• Fixed wireless not enable wireless when it is in disabled state.
• Fixed video streaming not always working properly.
• Fixed HNAP reporting or wireless client status.

Version 3.0.02 build 3:

• Fixed double NAT issue.
• Fixed issue with NMH series.
• Fixed PPTP client cannot get ICMP response from Internet.
• Fixed issue with NTP
• Fixed issue with L2TP UDP packets can be recieved in Internet side.
• Fixed TZO and DyneDNS not automatically updating.
• Fixed some Wireless protected setup issue.
• Fixed wireless channel 11 being unstable.
• Fixed some wireless throughput issue.
• Fixed UPnP issues
• Fixed ICMP packet fails to go through when over 20% payload
• Fixed QoS function when saving settings.
• Fixed Access restrictions not working correction when time expires.