Download SpeedFan 4.34

After an impressive run of about forty beta releases, Alfredo Milani Comparetti finally released the final release of Speedfan 4.34 on Tuesday. This small hardware monitoring program displays information such as voltages, temperature, the speed of the fans and the smart information of the hard drives. It is also possible, provided that the motherboard used supports, to adjust the speed of the fans. Below you can find what has changed since version 4.33:

Added

• full support for SiS964 SMBus
• full support for SiS966 SMBus
• full support for ULi M1575 SMBus
• full support for VIA VT8237S SMBus
• full support for VIA VT8251 SMBus
• full support for nVidia MCP61 SMBus
• full support to read internal temperatures on AMD K10 processors
• native nVidia video card (up to, but excluding 8xxx) internal temperature reporting
• full support for SMSC SCH5307
• full support for F8000 temperatures and fan speeds
• full support for SMSC EMCT03
• full support for WINBOND W83793G, including ADVANCED options
• support for Fintek F71782F hardware monitor at unusual addresses
• support for Winbond W83627DHG at unusual addresses
• support for ITE IT8726F hardware monitor at unusual addresses
• support for a new stepping of the Andigilog aSC7621
• SMSC LPC47M192 FAN DIVISOR settings in CONFIGURE / ADVANCED
• full PWM support to SMSC LPC47B397, including settings in CONFIGURE / ADVANCED
• preliminary DDR3 identification

improved

• DDR2 memory module size detection
• Tjunction detection for Intel CORE temperatures (you might no longer need the temperature offset in CONFIGURE / ADVANCED)
• Winbond W83791D properly handles higher fan dividers for fan1, fan2 and fan3 and shows fan4 and fan5 too
• CONFIGURE now allows to go as low as -60C when selecting the DESIRED and WARNING levels to let users of the RELATIVE Intel Core temperature reading properly configure SpeedFan
• restored the correct clock speed after resume from hibernation
• rewritten the logic of the usage of a synchronizer in the thread that reads CPU usage (this will fix the SpeedFan not exiting issue)
• address $2E on DFI motherboards is no longer scanned if the motherboard model starts with LP. If you have one of these models and you know that there should be a valid chip at that address, send me a SEND REPORT (INFO tab) with some NOTES
• mails sent by SpeedFan now properly separate headers and the body with a blank line
• new icon by Bengt Strom

Fixed

• an issue where Intel Core temperatures on multi core systems reported the same temperature for all cores
• fixed crash on several DFI motherboards
• fixed the detection of older revisions of the ITE IT8705F
• fixed ADT7475 temperature readings when in offset 64 mode
• fixed a bug when changing the type of data to be charted
• fixed an issue with SUN 2864 motherboard

[break]